This was designed so that even beginners may use easily.
Depending on site, site name is automatically changed and stored
(up to 10 site names).
Inputting site unique name can continuously connect
fusion number and perform work even when moving from site to site.
You can see fusion content using view function without printing.
(Black mark at abnormal part)
Outside temperature is measured and cooling time is automatically corrected
(shortened up to a maximum of 20%).
It is possible to see screen with back light function during night work.
It is possible to see work content in advance by using view item before printing.
The built-in printer makes it easy to replace paper and then makes output
easily and quickly.
Internal printer is installed, which prints quickly as
60 seconds during 40 point output
This is a product authorized for fuser performance check
by Korea Gas Safety Corporation.
Input power cable shall be 5.5mm2 or more,
and be as short as possible from input side(power generator).
Use the grounded power.
Combine heater connector before turning on power.
When a message "combine coupling" appears about 5 seconds after turning on
controller switch, remove foreign materials attached to coupling at this time
and then combine coupling.
Oil sensor is installed inside oil tank, and alarm message is displayed
if oil is deficient, so at this time, fill oil(alarm message disappears).
For oil, use #32 hydraulic oil during winter and #46 hydraulic oil during summer.